Tyrolit 115mm C-Trim Flap Disc 60G
Click Image for Gallery
115 x 60G C-Trim Flap Disc
Test the flap disc with unbeatable performance. The PREMIUM*** LONGLIFE C-TRIM provides an excellent stock removal rate and 100% use of the disc through trimming with consistent results.
The LONGLIFE C-TRIM can be used on high alloyed steels and stainless steel, as well as on unalloyed and low alloyed steels. Problem-free weld-seam as well as edge and surface grinding, particularly when used on powerful angle grinders. Thanks to its compact design, a long lifetime is guaranteed during deburring of sharp edges on thin sheets.
Trimming flap discs
When grinding with flap discs the optimum angle between the wheel and the workpiece is 15-25°. This means that the abrasive wears off more at the edge than near the bore. That’s why very often 50% of the disc cannot be used properly.
By trimming your product you can reduce the backing diameter, thus achieving 100% use of the disc. Importantly, the backing must be suitable for this kind of application. Please note that you can trim the backing only as far as the end of the depression.